Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a pix 501 and I need to let Exchange traffic through. I had done this before and it worked for me, but this time its not working. I cannot telnet to port 25.Please help. See below for my configuration. I am sure its something easy, but ...
Hi All,I need to setup access to one of my serversfrom the web.I need to open port 80Here are the commands I added on my pix 515 firewall.access-list 102 permit tcp any host 207.215.58.74 eq wwwstatic (inside,outside) 207.215.58.74 10.1.1.27 netmask ...
Hi All,I have a Cisco Pix 515 and a vpn group setup on it. I was wondering how to setup multiple vpn groups on a pix if possible.I am running IOS 6.33.Thanks,Paul Hong
Hi all,I am running SNMP on my cisco pix and when I ran the MRTG software:I get this error message:### Interface 1 >> Descr: 'PIX-Firewall-'outside'-interface' | Name: '' | Ip: '207.215.60.67' | Eth: '00-50-54-ff-34-12' ###### The following interface...
Hi all,I am trying to setup MRTG to monitor my pix 515 for incoming and outgoing traffic.I installed MRTG and perl, then create a cfg file.See below for my file:# Cisco Pix 515WorkDir: c:\Inetpub\wwwroot\mrtgTarget[mbcpix]: public@10.1.1.1MaxBytes[mb...
Here is the current config,Thanks: Written by enable_15 at 12:23:54.429 UTC Sat Sep 9 2006PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 100fullnameif ethernet0 outside security0nameif ethernet1 inside security100hostname kidscampusdom...
VJ,thanks for much for your reply.I tried all your solutions and my exchange server still does not work.the actual ip address is 75.32.25.34 when I tried to send an e-mail, it does not go through and when I do telnet 75.32.25.34 25,it failed too.Plea...
