Hi.I need to know if the N9K-M6PQ module supports Fex connections.I have an N9K-M6PQ module installed on a Nexus N9K-C9396PX, but I'm not sure if this module supports Fex being connected to it.Thank you.
Hi.
I have un Nexus 7k with two N7K-SUP (SUP1) installed and in service.
I need to upgrade the chasis to N7K-SUP2E without service interruption.
The quiestion is if one SUP1 and one SUP2 can work together...
I mean... I wont to remove de standby SUP1...
Hi. I have a Cisco 7204 with dual Sup720-3B in redundancy SSO mode. I want to select wich card came to be the active and wich will be de hot (standby). I really don't know how can I do this.Brgds.
Hi to all. Sorry for my poor english.I have a remote site (A) connected to a access router (B). The remote site(A) has a dedicate leased line to the access router (B) plus an ADSL backup (with a tunne GRE) to my VPN tunnel concentrator (C). All are r...
HelloI know that the Nexus N9K-C9396PX supports fex. What I need to know if the N9K-M6PQ module supports fex.On the other hand, thanks for the link.Thank you very much.
Thank you again Mark.
I need to know if I can remove de stby sup1 and insert thw new sup2 without problem.
Then, make the switchover and then, replace de second SUP1.
Brgds
Hi Mark, thank you for your help, but i need to replace de supervisor 1 to supervisor 2 (not the line card or modules) Also, i will replace the fabric too, but after of the supervisor change.
The 7k are running NX-OS 6.2.12
Brgds
Hi. Sorry for my english.The problem wit this is that MUST be disk0: not a sup-bootdisk o anything...My problem was the same:Router(config)#boot device module 2 sup-bootdisk:c6ace-t1k9-mz.A2_3_5.binFailed to set boot device module 2Failed to set boot...
Hi Jerry. Sorry for my poor english.Yes, you understood the question. The supervisors card was ordered on diferent times.By the way, I still not understand what is the election procces in wich always the same card is elected primary.Brgds
