About asaditian

asaditian · 11-20-2023

1. ACL on ISP G0/1 permits only 61.1.1.12.SA between R1 and R2 is fine and everything works fine, LAN to LAN is reachable.NOWI need to access 8.8.8.8, for which I need to nat my LAN ip 192.168.1.1 to 61.1.1.1 and I configure NAT on the R1 and tunnel ...

asaditian · 02-18-2025

If I understand your question correctly. . . you set ISE Profile asSet Default Privilege to 1Maximum Privilege set to 15.you are landing at the user promt > then you have to type enable and you will be placed in # mode ( this is expected behavior ) N...

asaditian · 11-21-2023

Thanks Rob, figured this as well. following is the edited NAT config and output Thanks again.

asaditian · 09-16-2021

Dear Rob, For instance, In case I have a /24 dhcp pool, and the untrusted ports are limited to 100 (as per your recommendation), wouldn't it allow an attacker to starve the DHCP in few seconds by sending 90 requests per second. on the other hand, is...

Member Since	‎09-16-2021 09:20 PM
Date Last Visited	‎05-23-2025 12:38 PM
Posts	4

User Statistics

User Activity

L2L VTI VPN goes down after NAT

Re: Authentication of cisco switch tacacs with ISE

Re: L2L VTI VPN goes down after NAT

Re: Dhcp spoofing attack