Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently engaged with a third party vendor that required us to setup 3 L2L VPN connections from a single host on our network to 3 remote end hosts. Due to our internal private address space in use overlapping with their address space we had to NAT...
Ok, I have been going crazy for 3 days now trying to get 2 Aironet 1310 AP/Bridges to connect the Root Bridge and Non-Root Bridge using Microsoft CA, Microsoft RADIUS and network EAP. I don't know if I'm just not getting it or what. The Non-Root brid...
Hi Seb,A Site to Site VPN is different thana Remote Access VPN. If you are using the wizards in ASDM there is an option for both when you start the VPN wizard (See attached screenshot). You can use a PSK in both scenarios and like stated before, the ...
Hi Seb,The Pre Shard Key (PSK) is a mutual password of sort defined by you and used in the tunnel configuration on both sides. When configuring your VPN, you will need to use the same PSK on both ends. I recommend making sure the PSK is complexHope t...
We ran into this all the time too and never really got the iPhone / iPad working using certificates over an IPSEC VPN connection. We opted to implement SSL VPN using the AnyConnect client. There is a cost for licensing the SSL VPN concurrent connecti...
Hi Sihanu,You probably could get a good start by taking a look at this document.http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00805733df.shtmlA couple of suggestions in addition to this example:Use certificates for au...
You should be able to use the copy command and copy from your startup-config to a TFTP server.FW# copy startup-config tftp:Address or name of remote host []? Destination filename [startup-config? !!!!!!!!!!!!!!!1234 bytes copied in 5.67 secsFW#Then r...
