Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI've got a VIC2-2FXO card where the voice port is being changed to a down state with the following error "%LINK-3-UPDOWN: Interface Foreign Exchange Office 0/0/0, changed state to operational status down due to cable removal". What I don't understa...
I need to setup a transparent proxy server on a relatively small network and I’m thinking WCCP and Squid would be a good fit. The network has a PIX firewall with three interfaces, the first interface connects to the internet router (not Cisco kit), t...
I have recently setup a Cisco 1751-v router with a VIC2-2FXO card and a BT phone line, however after several attempts I am unable to successfully obtain the caller ID. The IOS version is 12.4(19).The configuration of the voice-port is as followsvoice...
Sorry to keep going on about the same issue but I’m hoping with some persistence the gateway can be made to obtain the caller-id of an incoming call.In an attempt to rule out there being a problem with the IOS and DSPWare version I’ve changed the IOS...
Would anyone from Cisco be able to take a look at the PCM capture file in post 20 for me please.Also does IOS version 12.4(15)T9 include a newer version of DSPWare than is available with IOS version 12.4(25c)?
Sorry, guess I should have said received by the gateway and then interpreted by the DSP. Presumably if the PCM capture includes the tones then it will indicate that the DSP is failing to convert the tones into a caller id, or if the tones aren't pres...
Sorry to keep pushing this but would one of the guys from Cisco be able to analyse the latest PCM capture file I’ve uploaded (post 20) to see if the caller id tones are being transmitted. I’ve purchased a VIC2-2FXO card to replace and existing VIC-2F...
