Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If my ISP is logically routing between a routed interface on their end with an IP in the same subnet as my end's Layer 3 router SVI interface for VLAN 10, but the ckt terminates on a layer 2 switched interface on my end using vlan 10, does my ISP nee...
If I wish to remove a
route-map
from a BGP neighbor without removing the neighbor itself does the below work?
router bgp x.x.x.xneighbor x.x.x.xno route-map TEST
I need to test the configuration of Source-specific multicast in parallel to the current production configuration. I plan to use VRF-Lite to create a SSM-TEST VRF for this so as to separate the two routing environments. To accomplish this I assume ...
I have a 9500 switch with just AAA new model configured, nothing else.
I want to remove it so that I can then configure login local under the VTY lines. Can this be done and does it require a reboot? Or is it easier to just globally configure the ...
Thanks so much! If it can great, but if not what is the least intrusive command to clear bgp outbound if each neighbor has a different AS number association? i.e. how can I then just reset outbound BGP adverts for a specific neighbor/AS# in the leas...
Actually, if I just do a outbound route refresh, that should not be disruptive based on what I have read. The route refresh command being ...
clear ip bgp 192.168.12.1 out
