About ronin308

ronin308 · 09-15-2011

Hi, I am attempting to control this monitor via Crestron RS-232. While the DMM user guide includes the RS-232 commands for on/off and a few other things it does not include the comands to select the various input sources on the monitor.Searching the...

ronin308 · 01-16-2008

I have a problem that appears not to be covered in the troubleshooting docs.i have 3 4507Rs each with 2 Supe V Ten Gig supervisor engines.One one switch both supes display the problems on the other switches one supe shows the same problem.When connec...

ronin308 · 09-21-2011

JD, the LCD-110Q-PRO55 is a Cisco monitor so if I wanted to contact the manufacturer of the display I would have to do it through TAC since they are the support arm of the manufacturer.I know all about other manufacturers and the fact that some use ...

ronin308 · 01-16-2008

I have booted with no startup configuration and the problem still exists, the moment I get Switch> I can type about 3-4 commands before the switch reboots.As an additional thoughts these switches were up and running until last week.

ronin308 · 01-16-2008

I have now broke it in rommon, had it load a new image via tftp and it exhibits the same problem of getting to the command prompt and restarting.

ronin308 · 01-16-2008

Thanks Ankur, I did break it in rommon and did a confreg to tell it to ignore the startup configuration. Are you saying to just try a boot flash:/cat4000-etc-etc? I will try that and am attempting to tftp a new image to the switch. I am getting an...

Member Since	‎01-16-2008 09:02 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

RS-232 input control of LCD-110Q-PRO-55

4500 Booting problem

RS-232 input control of LCD-110Q-PRO-55

Re: 4500 Booting problem

Re: 4500 Booting problem

Re: 4500 Booting problem