Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the process for changing the domain ID of an existing Stackwise Virtual stack? Is it similar to VSS or is there a different method? Can you just change the domain ID and reload the stack?
I have 3 1852 access points. I have attempted to configure a couple of them as a controller. I have verified the software, 8.2.100. Show version shows:
AP Image type : MOBILITY EXPRESS IMAGE
AP Configuration : MOBILITY EXPRESS CAPABLE
I run the co...
I know that in order to connect the 2348TQ (6x40G uplink) to the 9372PX I need to use breakout cables with appropriate SFPs. My question is, is there any configuration to be done in order for the 2348 uplinks to work in this mode. Can I just create...
Has anyone seen or heard of an issue with the internal DHCP server in 6.0.199.4? We upgraded today and the internal DHCP server on both WiSMs went nuts. Client address assignment was sporadic, and eventually non-existent. Client would get associat...
That's what I'm trying to avoid. These stacks are already configured and halfway into production, but not yet connected. I know that the domain IDs need to be unique and that it will require at minimum a reload. I would like to know if it is as si...
The 40G interfaces are on the 2348. The 10G interfaces are on the 9372. The 40G interfaces on the 2348 will need to breakout, not the other way around. I've done breakout TOWARD an N2K before, but this is breakout in the opposite direction. As fa...
