Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have questions about the ntp broadcast (server) <--> ntp broadcast client.In my scenario is:On router R1 (NTP server on 1841 router) the ntp broadcast is active on Fa8 (trunk port).On SW1 (Catalyst 2960) the ntp broadcast client is on Fa0/13 (...
Hello,here is a simple setup. The home router is also modem/gateway and has its own DHCP server.How do I get the home router to recognize the network 10.0.0.0/24, it does not have the possibility to enter static routes.Ping is possible in the 10-netw...
Hello,I make backups of the AP's images to our TFTP server and have tried to open the "tar" files under linux to check the contents.This does not work. What type of compression is used by Cisco?Frank
Here are the two outputs of the running config.The devices are set up for test purposes only and have no security mechanisms set up!Router:rt1812#sho runBuilding configuration... Current configuration : 3051 bytes!! Last configuration change at 11:01...
Ok. Problem found. not all vlans were enabled on the trunk. Alternative vlan on the server set to broadcasting (VLAN 99), now it runs - stupid error - thanks for your help!Here are the new logs:Jan 4 09:48:32.993: NTP recv pkt on v4 socket, pak = 0x0...
On SW1 I have the debugging running, this is what I got. The time has not been corrected after 12 h.sw1#debug ntp allNTP events debugging is onNTP core messages debugging is onNTP clock adjustments debugging is onNTP reference clocks debugging is onN...
At the moment I have set the time manually on the client with about 3 minutes deviation from the server. This remains so and is not adjusted to the server.
