Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I am using Cisco MODELLING LAB for Ansible automation but only device connected to external connector is reachable from outside. How to make whole topology reachable using bridge mode please guide me.Thank you in advance.
Hi,I am using CML with external connector in bridge mode. I am able to connect outside network when my virtual device ip is in the same subnet of CML server. But I want to configure devices which are on different network and connect them with my netw...
Hi,I have to use ansible to manage cisco modelling lab topologies configuration. My ansible is in different VM so I am not able set up communication between them. Can someone please guide me how to set up ansible and CML reachability.Thank you in adv...
Hi,we have ansible server which is external to CML. We want to develop communication with CML. Can someone please help how to set up communication between CML and external apps. Thank you.
Hi ,We have installed CML for network simulation but we want to do some set up for monitoring of topology created in CML using Nagios or solarwinds. Is it possible to monitor CML devices using any monitoring tool?Thank you.
Do we need to bridge mode? I am using bridge mode but unable to set up reachability...ping between CML and ANSIBLE not working. Can you please help me for this troubleshoot.Thanks
Thank you Balaji for response. So do we need to uninstall CML and again need to re-Install after adding ISO images in path or is there any other way to add ISO images on installed CML directly. Looking forward for your valuable response.Thank you!
