Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,For the past few days, I’ve been trying to solve the issue mentioned in the subject. On an ASR 9902 running IOS XR 7.11.21, I applied a configuration by copy/pasting from an old ASR9006. Among the commands, there was also a comment that I wou...
Hi everyone,While deploying ISE 3.3 on VMware, I encountered an unusual issue. When I entered the "setup" command, there was no response. I’ve tried resetting the VM, rebooting it, and even powering it off and back on, but the problem persists.All th...
Hi all,I'm encountering an unusual issue with the Guest authentication process. We have a sponsor portal where each guest registering is assigned the "Self_Guest" type.We've configured the "Self_Guest" user type to store client MAC addresses in a spe...
Hi all,We need to retrieve logs related to recent changes in the Network Device Group settings. I have already checked the "Message Catalog" section, but I couldn’t find anything useful due to the large number of entries (over 2,000).Do you know if t...
Hi all,We are running a Cisco ISE 3.1P8 cluster with over 20 nodes and are planning to renew the Admin certificates across all nodes, including the Primary Policy Administration Node (PPAN). While reviewing Cisco documentation, I’ve encountered some ...
Hi @Scott Fella ,Thank you for the thorough and detailed responses you provided in the thread, they were very helpful.A possible alternative solution for the certificates used by ISE, specifically for EAP, would be not to create the DNS record at all...
Thank you, Harold, for the feedback!I tried entering those commands on an ASR9006 running IOS XR release 6.7.3, but the comment did not appear in the "show run". Perhaps the behavior of comments depends on the software release.
I tried entering the commands below, but the comment does not appear in the running configuration. I assume that you can only associate a comment with a single command and then commit the configuration.! OSPF CONIGURATION
router ospf 10
area 0
int lo...
Thank you so much, Harold!One last thing, just to confirm, is it only possible to add a comment to a single command?For example, after entering the following configuration, when running “show run router ospf” I won’t actually see the comment “! OSPF ...
Hi @jaideepchoudhary91 ,even though the post is a bit old, I'm replying anyway since I recently used this feature to remove a PE (on which maintenance activities were required) from the forwarding path.On IOS XR 7.11, once the graceful maintenance fe...
