Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have 3 sites, A, B, and C. A - Would be the HUB.B - Spoke - WorkingC - Spoke - Not working. From site A end device I can ping the ASA from site B, but I can't ping site C even with the same configs and tunnels are up I still can't ping ASA site...
I have a tunnel (ASA <> Meraki) tunnel is up and I can verify both ends.Problem is that, IPSEC from ASA can't encapsulate any packets but can decapsulate.
Hi, ASA (10.10.10.1 255.255.255.0) >> Windows Device (10.10.10.10 255.255.255.0) Ping won't work (I already disabled the firewall from Windows) Windows Device (10.10.10.10 255.255.255.0) >> ASA (10.10.10.1 255.255.255.0) Ping works. I already added...
I have zero knowledge on CME and CUE deployments and I only maintain it and do admin stuffs. Background story: My service module for CUE went dead last month and I can't retrieve any configs from it. I've replaced the SM and installed CUE, referenced...
Hi! Is it possible to have a CAT6 cable going to SFP module (C3850-NM-2-10G) using a SFP Copper Transceiver? Will it work for 10gb speed? If yes, what Transceiver should I get?
Not sure if this is relevant but as I told you tunnel is up I can reach from A end device going to C end device, it's just the ASA - C is not pingable. Site A - ASA confg: access-list int1/1_cryptomap_2 extended permit ip object 10.16.169.0 object 1...
they have separate configs for ACL and Tunnels. Lets just say spoke to spoke (A to C) for the tunnels. I can confirm tunnel is up because from A end device to C end device they have connectivity I can RDP and ICMP, but the ASA - C is the only issue. ...
sorry forgot to mention I also have this configured as well "management-access inside"And yes from site A end device going to site C ASA no pings. but from site A end device going to site B ASA working perfectly. C and B have the same configs for the...
