Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HIWe have switches connected over a wireless bridge, however VTP information is not sent across correctly.I have seen old community posts with older models, wondering if there is any official Cisco document suggesting that VTP will or will not work a...
My Current scenario is Wireless controller > Anchor Controller > Radiuswe are in the process of changing the RADIUS serverIn current setup traffic flows as WC>Anchor>RADIUSBut when I change the IP of RADIUS to new RADIUS server, it goes WC>RADIUS, do...
Rebooted CMX a week back, but CMX is still showing low count on active APs, is this a known bug? Placed AP Missing AP Active AP Inactive AP3224 2913 24 3200
HI We have two controllers - 5520 - primary(.5) and secondary(.7) in HA-SKURecently we upgraded the controller from 8.5.131.7 to 8.10.151.0Had a total of 112 APs on the primary controllerto avoid disruptions to service, we first upgraded the secondar...
We are in the process of migrating from 3.7 to 3.9, this will have extended outages etc, so wanted to know if we can add a server running 3.7 to an Ops centre running 3.9 as it doesnt work the other way round.
Ive changed the RADIUS IP on both the local and the anchor controller.There is a route to the whole 192.168.20.x range and the new RADIUS IP is just the next IP in the subnet
