Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm looking to boot one of two images available on internal flash of a 1921 router. Currently 151-1.T1.bin is being loaded at boot.Router#sho ver | in System imageSystem image file is "usbflash0:c1900-universalk9-mz.SPA.151-1.T1.bin Router#dirDirect...
I have read several posts about this not working when connecting to a VPN Concentrator. Not to mention I am experiencing first hand. Is anyone familar with why it work with MS-RRAS?I have searched and searched for related documentation but I can no...
Does anyone have any experience running a dynamic routing protocol over a GRE tunnel whose peer is through the internet? My question is, if so, have you run into issues of route flapping do to the potential stability of the Internet? Would it just ...
No, you understood my question. That's what I'm going to end up doing. I can send the D-chan out the DSX-1 port of a DSU and turn off rob-bit signaling.
Just to confirm, are you saying it worked fine for a few months and then stopped working? Or, you have been using PC DIMMs for a few months and have had no issues?
You could load share across the two links with two equally weighted routes. Or, you could inverse multiplex them if you porvider supports the option. If they are point to point, you can I-Mux them with an IMA card on each side.
In addition to authentication, also look at the speed which your remote router is trying to connect. If the call is not able to connect at 64k, I have seen instances where calls drop after a 30 second period. Try forcing the call to connect at 56k.
