Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,up to now I'm used to configure interfaces on 2960 or 3850 switches. Now we've got two SX350X devices, and I tried to setup interfaces as trunk or access (CLI only!). I'm unable to find a way to get rid of any trunk config, once it is been there. ...
Hi, device with IP address 192.168.0.1 is connected to a Catalyst 2960. When I ping to that device and do a show ip device tracking all command, this IP address is listed as expected (state: active: source: ARP). But when I do a show arp, this IP add...
Hi, on an 2960XR at one of our branches there are three vlans: 5 (management), 10 (data), 20 (voice). Switch is uplinked to a MPLS carrier CE, which is gateway for all three networks. Switches management IP address is 192.168.5.2, default gateway is...
Hi, just to doument this, I finally was able to get an interface back to "normal" with no switchport access vlan no switchport trunk allowed vlan Regards,Stefano
Hi Flavio, sorry, I was to fast. It still does not work. I still see multiple conflicting settings on the interfaces. I cannot find a way to make an interface EITHER access OR trunk. A show interface TE1/0/1 does allways show me a mix of these config...
Hi Georg,it's indeed configured for IP routing. Due to this I can see IP addresses in different Vlans, with both commands. But I would expect that "show arp" is similar with "show ip device tracking all", or at least a subset.ThanksStefano
