About mirror512

mirror512 · 09-24-2011

There is a drag drop in SWITCH exam and there are different answers on internet . The questions isIn one dump it says ip routing has pripority more than voice and in one it says it comes at bottom below network management.I want to know what is true

mirror512 · 09-24-2011

I have not been able to find the answer of this questionWhen you enable Port-security on an interface that is also configured for a voice VLAN, what is the maximum number of MAC addresses that should be set on this port? Select the best response A....

mirror512 · 09-19-2011

I am trying show vlancommand but could find there which vlan is native.How can i check that

mirror512 · 09-18-2011

ho guys ,I am studying for switching and i am totally confused between these things. I want to what is the difference between them and int fa0/1no switchportip add 10.10.10.1 255.255.255.0interface vlan 1no switchportip add 10.10.10.1 255.255.255.0in...

mirror512 · 08-29-2011

I have seen the lab for CCNP ROUTE exam it stataes that you must aable to ping and telnet from loopback interface 101 on R1 to ip address like 172.1.1.1Now is that ping different from normal ping. because ping command is same i think

mirror512 · 09-18-2011

then what is the use of this commandinterface port-channel 1 no switchport ip add 10.10.10.1 255.255.255.0

mirror512 · 09-18-2011

I created interface vlan 1interface vlan 1 no switchport ip add 10.10.10.1 255.255.255.0 then int range fa23/24channel-protocol lacpchanel-group 1 mode activeI want to know do i need to create port channelbecause i did not create one but it gets aut...

mirror512 · 08-29-2011

There was one MCQ question where i had to choose three feasible successors and one of them had AD = FD.so i was confused whether i should choose that as answer or not.

mirror512 · 08-29-2011

thanks ajay ,One thing more , when they say you should be able to telnetWhat i am supposed to do do thenI mean unless there is access list , if i can ping , what can be the problem with telnetor do i have set vty password on destination router so tha...

mirror512 · 08-29-2011

But mymain doubt is what if AD == FDIn some book i have seen AD can be = FD to become feasible successor.Is that correct

Member Since	‎08-21-2011 06:55 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	14
Total Helpful Votes Received	5

User Statistics

User Activity

WHich has more packet cos priority ip routing and voice

Need to fins answer of port security in voip

Which command is used to check the native vlan

What is the diff between interface vlan and portchannel

How to ping from loopback interface of router

What is the diff between interface vlan and portchannel

What is the diff between interface vlan and portchannel

In EIGRP does AD < FD or AD <=FD

How to ping from loopback interface of router

In EIGRP does AD < FD or AD <=FD