Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey, everyone.
I'm trying to set a SD-ACCESS envionment follow this document.
However I meet this error while set a L3 switch as a control plane.
Failed to add device XXX.a.com to the Fabric Site/Zone. Please configure Loopback0 interface with an IP ...
My WLC have an aaa-policy variable. After pushing the provision, the aaa-policy setting disappeared.
I want to know where in DNA Center I can set my aaa-policy without being deleted.
The aaa-policy is like this
[Before provision]
wireless profile ...
Thank you for your reply.
Yeah, I noticed this, and set a /32 IP to the Loopback0 interface. And set it to my ospf x area x network.The loopback 0 address can be pinged from DNA Center.
And it also failed, show the same error message......
