Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know that in order for host 1 to receive it's IP config from the DHCP server, the command 'ip helper-address 10.1.1.1' would need to be applied to the Fa0/1 interface. Is this true?
Is an IP helper-address needed otherwise packets with multicast/unicast/broadcast destination ip addresses won't be forwarded, or is it port 67 and 68 packets?
What happens when the transport input ssh command is entered on the switch vty lines?The switch requires a username/password combination for remote access.The SSH client on the switch is enabled.Communication between the switch and remote users is en...
Regarding the same config, If the port fa0/11 fails, will port fa0/12 change to Forwarding role quickly? Is switchA configured with the command spanning-tree vlan 20 root primary? Is the spanning tree mode is the faster version 802.1w or the original...
But a switchport can become a trunk port through static or dynamic configuration, right?Can a trunk port be created without the no switchport mode access command?
I figured switchport mode trunk would be there somewhere. Do you think any channel group commands should be added to it? Or Switchport mode dynamic desirable?
