Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, Quick question. I was given a working Aironet 1262N without realising it had a lightweight image loaded. As it is EOL I can't get the autonomous image anywhere, without resorting to other methods (which I would not do, for obvious reason...
Hi everyone, newb here. I picked up a cheap 1941w, but know very little about them and as such this is a very steep learning curve. This particular one has a VDSL2 module and 1x 8 port POE gigabit module. I have a VLAN that covers 8x POE gigabit port...
I answered my own question. It is a LAP1262N so it has the lightweight image loaded by default. I have found one which has the autonomous image flashed before it was EOL.
Success! It turns out I hadn't configured any firewall policies yet (d'oh!). So the routing was all good, just being blocked by the firewall. Here are the changes I made: ip nat inside source list 1 interface Ethernet0/0/0 overloadip route 0.0.0.0 0...
Hi there, Thanks for the replies! You are correct that there was no ip route, but I have made all of the suggested changes with no luck.WAN shows connected, VDSL has synced and I have an IP address but none of my VLAN's can access the internet. I can...
