Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of ACE 4710's that I am deploying within a datacenter. The primary and secondary ACE appliances have identical configurations except for the IP addressing and priorities for FT. The FT peer is going into a TL error state. On the prim...
Does anybody know of a confirmed release date for the NX-OS revision that supports 1G connectivity to the Nexus 5548. The documentation says that 1/10G connectivity is supported on all 32 ports, but there is a disclaimer that states the code to supp...
Maria, thank you for the advice. I do have a habit of speaking in absolutes when many of our questions often have many answers. I joined the forum because I expected a lot of intelligent discussion and I have been very impressed with the well thoug...
Maria,I appreciate the hard work you and others put in your responses and thank you for the background and references. I did not know at one time it was a default setting on the sender. From what I've read thus far, the only default loop preventi...
Peter, I agree with everything you, John, and Maria said regarding having the ability to determine what's allowed to enter your AS, except the part as to being the reason it performs this way in the programming of the code. The software was written ...
I don't see where anybody answered your actual question. I won't go into too much detail, but here's the reason the advertisement is sent and it's up to the receiver to prevent the loop.When a BGP speaker receives BGP routes, it runs through the BGP...
