Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am wondering if anybody has the "best practices" for setting up the 350's for ISP usage. With 10-30 client on each AP/BR.Any help would be most appreciated.-Jay
I have a problem with some of my clients. They have static IP's but attach to the AP350 with address 0.0.0.0 and with : "OK, WEP, IP Forwarding Agent, BOOTP/DHCP Client, IP Virtual Router." in the Status cell.What would cause this?Thanks.
I am looking for an application (jtapi?) for an alert to a system, phone, or email to me that let's me know who dialed 911 in relative real time. I've seen some conversations of it but have seen no definitive answer.Is there a way to easily tell who ...
I have done this too, but never get any good data. It's like the CDR is not logging calls.I do a simple:select finalcalledpartynumber, dateTimeConnect, datetimedisconnect, callingpartynumber from CallDetailRecord where finalcalledpartynumber like '80...
If I do a "Sysopt connection ipsec-permit" I get:pixfirewall(config)# sysopt connection permit-ipsecERROR: sysopt connection permit-ipsec configuration cannot be modifiedwith PIX Easy VPN Remote enabled.Not sure how I would enable it in the acl as yo...
I am in the process of setting up a VPN process exactly like this. The Software VPN client is working good right now to our VPN3005 concentrator, but I am installing IP Phones out in the field. The HW solution is the only way to go then.I was concern...
The amp is not it. I took it off and it did the same thing. I replaced it with another AP350 I had and everything is perfect. Both AP1200's do it constantly all day. I'm not sure what my next step should be.
