Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are currently using Microsoft Unified Messaging with CUCM 8.5 through a SIP trunk. This is working flawlessly and has been for the year now that it has been in place. Kudos to Microsoft and Cisco for good collaboration.Presently we are looking to ...
I recently upgraded to UCM 7.0 from CM 4.1.3. After the upgrade I have been noticing a various phone numbers are flagged as international when they are processed by the h323 gateway. It seems to be relative to a particular area code. All of these cal...
In short you have to bypass the ASA in order to satisfy the UAG requirements.What you need, if you don't have one in place, is a network switch or hub that sits between the Internet router and the ASA. You will connect the external interface of your ...
That other customer was me. The solution was overlap receiving. We saw that some numbers were sent in full in one setup message, but then others were short one digit. When we applied overlap receiving this immediately and permanently resolved the iss...
Thanks for the information. It does work to force the isdn type to national. Any idea why this particular area code gets flagged as international? Here's my serial config:interface Serial1/0:23 no ip address no logging event link-status isdn switch-t...
