Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of Cisco 2100 series firepower devices that I am configuring for deployment at two separate locations. Currently when powered on, they go into rommon, without any prompt from me. Once I type the boot command they will complete their boo...
Actually, it doesn't. I'm not asking to learn about JA3, I'm asking how would one block those protocols on a FTD, but still allow AnyConnect through. And never answer a post with, "Just google it." Have the decency to assume the person has already do...
It was set to 0x0. I went through the prompts of the confreg command and the value had changed to 0x1 when I was done. I did not see this step in any startup guide, so just a bit annoyed that this was buried so deeply in Cisco's documentation.
Shortly after posting I found this: https://quickview.cloudapps.cisco.com/quickview/bug/CSCvp57772 The bug report linked solved my issue, though I find it weird as these are fresh from the box appliances.
