Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When i try to Ping fron internal router (192.168.40.2/24)to Layer-3 switch(192.168.40.1/24) same subnet ip address, it's not pinging. NOTE: topology is attached below Configuration:INTERNAL ROUTERredundancy!!ip tcp synwait-time 5!!!!!!!!interface Fas...
SCENERIO: i have configured dmvpn from HUB-ACTIVE, HUB-STANDBY to SPOKE2.I have configured 2 tunnels on HUB-ACTIVE & HUB-STANDBY pointing towards SPOKE2, while SPOKE2 has 4 tunnels, 2 for HUB-ACTIVE & 2 for HUB-STANDBY.[ Note: on each HUB 2 tunnel...
Requirements: HUB-ACTIVE, HUB-STANDBY, SPOKE2 must communicate through DMVPN, using EIGRP routing protocol.
But when i advertise the network connected to the routers (hub-active, hub-standby, spoke2), it showing the error on all three routers:
*Dec ...
My config is all right,here's config:SPOKE1:Interface IP-Address OK? Method Status ProtocolFastEthernet0/0 1.1.1.4 YES NVRAM up upFastEthernet0/1 192.168.30.1 YES manual up upFastEthernet1/0 unassigned YES NVRAM administratively down downFastEthernet...
Scenerio: There are 3 routers [2 hub (HQ-R1 & HQ-R2), 1 spoke router(B2)]. I had configured dmVPN and used EIGRP on all three routers for communication. But it is only showing neighbour with HQ-R1 and B2 only.i want all three routers to be a neighbou...
EXTERNAL ROUTER:#sh ip route3.0.0.0/24 is subnetted, 1 subnetsS 3.3.3.0 [1/0] via 10.10.10.110.0.0.0/8 is variably subnetted, 2 subnets, 2 masksC 10.10.10.0/24 is directly connected, FastEthernet0/0L 10.10.10.2/32 is directly connected, FastEthernet0...
I didn't do anything, just closed the gns3 and reopend, now it's pinging.but got new problem, when i try to ping from L3-sw to 192.168.30.1/24 its showing : Sending 5, 100-byte ICMP Echos to 192.168.30.1, timeout is 2 seconds:UUUUUSuccess rate is 0 p...
HUB-ACTIVE:1.1.1.0/24 is directly connected, FastEthernet0/02.2.2.0/24 is directly connected, FastEthernet1/1192.168.10.0/24 is directly connected, FastEthernet0/1172.16.10.0/24 is directly connected, Tunnel190.90.90.0/24 is directly connected, Tunne...
SPOKE2 cannot find the route for 192.168.50.0/24 using eigrp, now what shoud i do ??HELP !! HUB-STANDBY:!!!!no ip domain lookupno ipv6 cef!multilink bundle-name authenticated!!!!!!!!!redundancy!!ip tcp synwait-time 5!!crypto isakmp policy 1encr 3des...
now showing this error on HUB_STANDBY: *Dec 5 20:03:43.723: %DUAL-5-NBRCHANGE: EIGRP-IPv4 1: Neighbor 200.200.200.2 (Tunnel3) is down: retry limit exceeded
