Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured CME + CUBE + SIP Trunk (Telco)Customer uses 8861 SIP IP PhonesIOS ver: isr4300-universalk9.17.03.04a.SPA.bin As per ITSP/Telco requirements, below commands must be turned off:no ip http serverno ip http secure-serverno ip nat servic...
Understood CUCM and CUCM SME is very similar except CUCM SME wont be used for phone registrations and used mainly for call routing between clusters or various devices as per below discussion link: https://community.cisco.com/t5/ip-telephony-and-phone...
Understood, thank you for the reply. I appreciate it. Is it safe to say that it's best practice for SME to configure the Device Pool, Trunk, Partition, CSS, etc. (and other Voice Gateway related config) on the SME itself if i'm adding a CUBE/H323 or ...
Thank you for the reply. I appreciate it. Is it safe to say that it's best practice for SME to configure the Device Pool, Trunk, Partition, CSS, etc. (and other Voice Gateway related config) on the SME itself if i'm adding a CUBE/H323 or MGCP VG for ...
