There is a device that was discovered while doing a Network Discovery that was found by CDP. The device is Unreachable so it does not display on the Topology map. We are not sure where the device is connected to and would like to find it. Is there...

We have recently installed a new LMS3.0 CiscoWorks. I have run a discovery and can reach all devices except for our CAT1900 switches.They report back as:First Found by Module - CDPStatus - UnreachableI have verified that CDP is enabled on both ends ...

This may sound simple, but how do you determine at what percentage utilization has an impact on flow. For example: when monitoring a 10/100Base-t port on a 2950 i see port utilization at 2%. Fine, but at what point should I be concerned. I have bee...

I have a two fold question.One: Is it okay to use an FXS port to connect to a PBX.Two: Can I use PLARS to "connect" an FXS to a ip phone.The reason is that I have a MC3810 with 6 FSX lines that I would like to use for an emergency back up.Thanks