Hello,
on fresh installation of ND 3.0.1i on vCenter, Nexus Dashboard Insights service fails while trying to get enabled with message:
job/pre-enable has failed:
Does anyone have a clue of the reason?
I'm running 3-App nodes, it's a small lab set...
Hi, Upgrading a DNA Center in 2.1.2.6 version from system version 1.5.279 to 1.5.288 stops at 60% in phase 7: maglev system_updater update_info System update status: Version successfully installed : 1.5.279 Version currently processed : 1.5.288 Up...
Hello,
For Nexus Dashboard Insights, I think it is would be interesting to have:
- Correlation with the Faults that are displayed in ACI.
- Support for ESG (there is a lot of anomalies raised due to the lack of ESG support..)
- Interface inventory ...
Hello,
I re-deployed the ND nodes with the configuration you suggested and it worked!
Previously I was using 500G thick provision, as the total datastore size is 3.49 TB, and with previous version this setup worked well.
Thank you very much,
Helena
...
Hi, update:I ran a maglev-config update wizard just to add a static route, and after that I tried the upgrade again: this time it worked fine: System update status:Version successfully installed : 1.5.288Updater State:Currently processed version : NO...
Certificates are also ok: $ sudo maglev-config certs info--------------------------------------------------------------------------------certificate start date end date--------------------------------------------------------------------------------cr...
Hi, For the node, it seems to be ok: kubectl get nodes NAME STATUS ROLES AGE VERSION192.168.x.x Ready master 346d v1.15.3-cisco And for the version, it's 2.1.2.6, and I already ran the report but it doesn't help very much...
Community Statistics
Member Since
12-08-202112:35 AM
Date Last Visited
09-13-202402:13 AM
Posts
13
Awards
Community Spotlight Award
English Community CIUG Member of the Month, November 2022