Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi expertsI’m deploying new images on my switch 2960 24TT L. After installing the new image (c2960-lanbasek9-mz.122-58.SE1.bin) and reboot the switch I have always this error message : “Error loading "c2960-lanbasek9-mz.122-58.SE1.bin"Interrupt withi...
Hi,We are installing many AP on my office. I must write a rules that establish the minimum signal required before installing a second AP or a repeater in the same location. Someone can tell me what is the minimum signal power is acceptable before in...
Hi,I'm looking for documentation about how the acl handles fragmented packets. Let say that I have the following config in my access switch: class-map match-any MyACL1 match access-group name MyACL1 class-map match-any MyACL2 match access-group na...
Hi Paolo,I need your help or any other person because, I have the same issue with my 2811 router. System configuration :c2800nm-ipvoicek9-mz.124-24.T3.binHWIC-2CE1T1-PRI, PVDM2-12DMThe voice port don’t appear. What can I do to fix this issue ? I need...
Thank you Peter for your rapid answer. It works very well after entered the command that you shown me.Before I had entered the command boot system c2960-lanbasek9-mz.122-58.SE1.bin without the word flash.Regards,
Hi Abdulrasheeth,I'am not expert but I have a good experiences in FWSM. Maybe I can help you. Is your switch knows networks 10.101.101.0 and 192.168.200.0 as connected networks ?Can you show your config ?regards,
