Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm appealing the community to see if anyone has wccp setup on a 6500 with an 810 barracuda. I've exhausted many efforts as the configuration on the 6500 chassis is pretty simple by just defining the 'web-service' which i did. But the switch still ...
negative, after getting new hardware from barracuda then the device kept on going into kernel panic, i've moved on to demo'ing an ironport. barracuda says they support wccp but have little to no knowledge or documentation on what it takes to make it...
did you add device-traffic-class=switch to cisco-av-pairs on ACS? Also, i had to change the native vlan on the supplicant switch side (acs adds this to the port config).I cant seem to get hosts on supplicant switch to do dot1x for some reason though...
