About amaerklin

amaerklin · 10-06-2011

Hi all,I'm trying to log commands with my ACS 4.2 version, but the cmd section remains empty. Can someone help me to figure out why the commands are not logged?infrastructure is configured for accounting as follows:aaa accounting exec default stop-on...

amaerklin · 09-08-2011

Hi all,I have an issue bringing up my RMA'd primary ASA unit.So what happened so far:1. primary unit failed2. secondary took over and is now secondary - active (as per sh fail)2. requested RMA at Cisco3. got ASA and checked that Lic (SSL), OS (8.2.2)...

amaerklin · 01-29-2010

Hi ExpertsI heard about the capability that the AnyConnect 2.4.x is able to reconnect a previous DTLS session without re-entering the xauth credentials? Can any one tell me were this feature can be enabled on the ASA with 8.2.2 code? I'm looking as w...

amaerklin · 09-11-2011

Hi Varun,I was able to put in the commands you mentioned and afterwards i fired up the ASA with all cables plugged in, and synchronisation started without any issues.After some time i did a failover active on the standby unit to make it the active on...

amaerklin · 09-08-2011

Hi Varun,Thanks for your help!I will modify or extend my config on the primary ASA without all the cables plugged-in.Afterwards it should be straight forward to fire up the primary unit and the secondary will replicate its config to the primary u...

amaerklin · 09-08-2011

Hi Varun,Thanks for catching-up this thread.Here you go:sh run fail on secondary - active:failoverfailover lan unit secondaryfailover lan interface Failover Ethernet0/3failover key *****failover link Failover Ethernet0/3failover interface ip Failover...

amaerklin · 01-29-2010

Hi Simone1. if you're using outbound vpn (ipsec) to a headend located in the internet you'll need to open udp 500 for isakmp and udp 4500 for nat-t and IPsec over TCP will be using tcp 10000 if cisco is used.2. you'll need to add the following to you...

Member Since	‎10-23-2009 01:34 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	9

User Statistics

User Activity

command accounting not working in ACS 4.2

Replacement of primary unit failed! (ASA5510 active/standby)

How to enable Auto-reconnect capability for AnyConnect

Replacement of primary unit failed! (ASA5510 active/standby)

Replacement of primary unit failed! (ASA5510 active/standby)

Replacement of primary unit failed! (ASA5510 active/standby)

Re: ASA 5505 first configuration - no connection with external V