Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a stack of 4 C9200L-48P-4X switches running 17.09.05 cat9_lite_iosxe which I cant upgrade.I tried copying the 17.18.04 to flash: but cant install due to insufficient memory.Now I put a usb drive in the switch and ran: install add file ...activ...
On a cisco wlc5500 I have a flex connect group. In that group there is wlan - vlan mapping. On that tab there is a checkbox called: Override VLAN on AP.The situation is that I have AP's on two different native VLAN's in this flex connect group. The n...
It took me a long time to find out why I couldn't connect to my Cisco C1000-8p switch. Turned out that the port-channel set up with GLC-LH-SMD SFP's does not work. When we remove the port-channel and connect over a single trunk setup the connection w...
It is running!!!After Install remove inactive I still found a file in flash-1: from the new firmware.I removed that file (which freed up enough space), and copied the firmware from USB drive to flash: again.Then I ran install add file .......Thank ...
Found something ....The USB drive is not in the active switch of the stack, but in a member switch.I can try tomorrow if it is able to upgrade when i place the drive in the active switch.Still there is the riddle why it will not uprade from flash, wh...