Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a router to terminate connections from PCs running V4.0.5 of the VPN client. However, on trying to connect to a server on the private side of the network, the connection fails and, on the syslog server, the following messages are lo...
I need to allow access to PCs behind a Borderware firewall performing PAT running the VPN client to a PIX running 6.3 - what ports/protocols need to be opened up on the Borderware firewall? As far as I can tell, it will be UDP port 500 and TCP port 1...
Other than looking at the date and timestamp on the directory that CSACS for Windows Eval was installed in, is there any way of determining when the eval license expires? I've had a look on cisco.com, google etc. and in the server's registry but I ha...
Rick,The ACL had a deny on the full class A subnet in ahead of the permit I had added towards the end. Moving the permit to the top had the desired effect. I should have spotted that one a lot earlier
If you have an access-list restricting traffic outbound from the interface that the exchange server is on:Addaccess-list permit tcp host any eq 26This will allow TCP port 26 to talk to any host, which is required if Exchange is resolving MX hosts t...
As well as configuring WINS server addresses as part of the VPN Group, depending upon the operating system the user has on their home PC, it may be necessary to change the workgroup name to match that of the domain controller - without this, the netw...
Steve,The only way I have achieved this in the past is to have a device, such as a PC running remote control software or a router, on the inside of the PIX that you can connect to, then initiate a telnet connection back to the PIX.
