Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All I ve enabled snmp on asa to allow dmz server access the monitoring server.Its saying cant "UNKNOWN: Get https://10.56.130.114:18443/query/check_nscp_version: dial tcp 10.56.130.114:18443: connect: connection refused " But the rule is actually ...
Hi All its been a while since i worked with switches in a stack. I have 5 and the have massive cpu for last 5 days down to fed processes. I see there is a bug advertised by cisco. But in the short term I want to reboot. I have no support hardware or ...
Hello,I was wondering if I need to add a static routes or ospf In order for my two routers in gre tunnel to communicate?I ask cause once I configured my tunnel, I seethe protocol for my tunnel is down and I have no route In my "sh ip route for destin...
?An Ethernet frame arrives at switch SW1, entering on port F0/1. F0/1 does not trunk. SW1 forwards the frame out F0/2. Which of the following statements is true about the logic SW1 uses when forwarding the frame?a. Forward based on MAC table entries ...
Hi I am using a 3COM and cisco switch. I have a GBIC GLC-SX-MM on one side and a 3com SFP Transeciver on the other side)My machines on each side canot ping. On the same side its ok.I htought there was little or no config in cases like this?I have ne...
yes i believe we are using hair pinning but i havent heard of this term before.... as per conf, the dms are all part of port-channel1.xx ( xx being a sub port intrerface) so yes the traffic is physically using same interface for traffic. However we a...
"I don't want to shell out for IP services if OSPF v1 on IP Base will do the job." With this comment id say the person is an IT person. I Doubt end users would ask for such a question!!!
HiU n can only have 1-5 port channels, u create you vlan and assign its interfaceThen you creat you port channel and add the vlan to itGlobal config, int port channel 5Switchport access vlan 3The int are already int the vlan from earlierSent from Cis...
Sorry but I'm back again! Still unsure ! A or B, I am again going on b as the frame must have a common vlan with fa02 and so the frame is forwarded out fa 02 ..A switch get frame on int fa01, if it doesn't know where to send it it floods the frame, b...
Thanks guys for replays, I think the two other answers are like I thought but based on Sandeep.... Answer , I see answer a is correct as based on the vlan and not on basic switch forwarding if no Vlans had been configuredSent from Cisco Technical Sup...
