Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Friends,I have a query on the Cisco 831 series router. The Cisco 831 series router has 4 10/100 switch port. This router belongs to Ethernet to Ethernet router Category . Now can I connect 4 seperate routers on four 10/100 ports of 831 series ro...
Hi Folks,I have a query on the incoming calls on the ISDN interface. Is there any way to disable incomming calls on the ISDN interface but allow out going calls through that interface. The topology is explained below.The Central site is connected to ...
Hi Guys,I need some help in configurations for router dialing out to Internet using Dialup modem. Is it possible for router (2610/1750 with Async/Sync port) to connect to Internet via dialup modem (DATA) dial out using a valid ISP Internet account / ...
Hi,I have a cisco 1750 router with Wic-2A/S and Wic-1B S/T in one of the access location of GTB. The connectivity to Distribution location is via 64 Kbps LL and ISDN backup. The problem is with fastethernet port on the 1750 router. The Fastethernet p...
Hi ,I have a question regarding the DRAM populated in 2610 series router. There are twenty online 2610 routers in one of my customer place. They need to upgrade the IOS from existing 12.0 to 12.2T. The FLASH and DRAM requirement for 12.2T (FLASH 16MB...
Hi Sankar,Thank you for your info..I was able to get one link from cisco http://www.cisco.com/en/US/products/sw/iosswrel/ps5413/products_feature_guide09186a00801c574b.html#54444which say how to configure each port. They have mentioned only two port i...
Hi,Hope this might help you. Can you issue the 'sh pci controller' command and review the following output information. This procedure is not documented but may be it works.'show pci controller' and parse the output as below to>find out.>>Note down v...
Hi You can set the load interval to 30 seconds and observe the link utilization in term on number of packet( in bits) across the interface you wish to observe every 30 seconds. Default value is 5 minutes.Hope this helps you !regards,Pradeep
You can try out the following options1. Configure the interesting traffic using dialer list. (basically the data traffic based on ip address)2. Apply the dialer list to the bri0 via dialer group statement.2.At the remote location configure a backup i...
