Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cable source-verify dhcp clarification. How it works !!!Cable-source-verify is a feature where the CMTS will watch the DHCP packets going by and only allow IP packets to flow to clients for which it has seen an IP address be assigned by DHCP. It kee...
Introduction:This document talks about the LNS configuration and troubleshooting which terminates PPP connection from PPPoE client over L2TP.For PPPoE client configuration, visithttps://supportforums.cisco.com/docs/DOC-6050For LAC configuration and...
Introduction:This document talks about the LAC configuration which terminated PPPoE connection from PPPoE client and based on the username i.e domain, it runnels the user via L2TP tunnel to LNS.For PPPoE client configuration, visithttps://supportfor...
Configuring and Troubleshooting VWIC2-xCTE1-PRI Modules for Inbound ISDN Multilink PPP Data Calls We have seen more and more customers are now moving away from traditional NM-xCTE1-PRI and HWIC-xCTE1-PRI modules which supports data and modem calls...
Hi Ricart,We do not have any specific performance docs that reports the numbers in that area because it is more or less a generic testing for the same feature.Now, to answer your 2nd question, if the authorization is configured via RADIUS, then route...
Hi Ricart,Actually, they both serves different purpose. Per-User ACL via RADIUS/AAA is per user as it says and it gives more control to network admin about the user's ability. ACL under the virtual-template will be applied to all the virtual-access i...
Just to add some more,If you are using "dialer-watch" scheme to activate a backup link, its not dependent on interesting traffic to bring up the backup link. So in that case once the primary goes down, the backp link will be activated by passing the ...
Hi thete,Here are some links that has some sample configs and troubleshooting tips. The configs for different modem modules will be same as discussed in those links.Configuring Dialin with the NM-8AM or NM-16AM Analog Modem Modulehttp://www.cisco.com...
Juan,You can upgradeto the next version if available.Before upgrading the modem to a new firmware version, please check if the new firmware version has been certified by your wireless service provider. Using an uncertified firmware version on the mod...
