Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a C1310 (channel 6) with a 1 watt 802.11g amp connected to a outdoor omni antenna. I have about five Linksys WET54G clients (external 14 db patch antennas) working just great at 54Meg 802.11g connections.Now for my problem:I have one Linksys ...
Does anybody know of a 4.9 GHz Cisco method or product to address the licensed spectrum for Homeland Defense?I am looking to set up a Mission Critical Local Broadband wireless network which operates in the licesed Homeland Defense 4.9 GHz spectrum.
I rather like the Cisco Linksys WET54G bridge radios. I am placing them inside an outdoor patch panel antenna and using the Linksys Power Over Ethernet injector so that I only have to work with ethernet cables from the outdoor cleint radio.I would l...
I am setting up several 802.11g access points. They will be configured to only allow my 802.11g (Linksys WET54G) clients associate. I have configured my Cisco 1310 APs not to allow 802.11b connection rates. Has anybody done this and how well did i...
Can a "350 wireless bridge" be upgraded to IOS ?From what I gather through trial & error and reading, the "350 workgroup bridge" can be upgraded to IOS but not the "350 wireless bridge".Not knowing the diff, I tried the "350 workgroup bridge" IOS upg...
If everything is a point to point (instead of point to multi-point), you should use only dish antennas.I dont think a WET54G will do 30 miles (802.11g OFDM) without some serious antennas and possibly an amplifier on it. The WET54G in only 12 milli-w...
I have acheived 13+ miles at 54 Meg 802.11g distances without the use of amplifiers while using the Linksys WET54G 12mw radio at the remote locations and a non-cisco AP at my base. My tests using only 1310s for the AP and client did not even come cl...
Thank you dixho,Would you please show me a sample config of where to place the "erp protection cts-to-self" setting. I have a Cisco 1310 running version 12.2(15)JA and I am not sure where to place the command.I beleive the command "erp protection ct...
YUP - Cisco documentation for using an external Radius server (FreeRadius) is rather hard to find.I have some Cisco 1310 APs I would like configure to use FreeRadius. I am just about at the point to consider selecting another brand of APs just becau...
