Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm configuring a new wireless network using 3850 as a controller and 2702I access point. When a client (iphone) attempts to connect to an SSID it fails and the following is logged on the 3850 console: *Jan 13 21:09:25.790: *%APF-4-ADD_TO_BLACKLIST_R...
I'm trying to setup my 3850 as a controller to run 2702 APs. The AP have been previously used with a different switch that is now gone. I get the following errors on the 3850 when AP is trying to connect: *Jan 13 04:10:49.586: *%LWAPP-3-AP_DB_ERR1:...
Thanks Haydn for the link to the WLC config blog, it was very helpful. I was missing client vlan defaultin my wlan configuration. All works fine now. I'll investigate the possibility of deploying a separate 9800 controller. My current setup is 4x385...
So I tried to add the adder licenses by typing the following:license right-to-use activate apcount 25 slot 1 acceptEULA And the AP was able to register and join. So it all works!!Thanks very much for all your help!!
How can I tell if I have the right licenses? Here is what I get from RTU license: switch1#show license right-to-use summaryLicense Name Type Count Period left----------------------------------------------ipservices permanent N/A Lifetimeapcount base...
