Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm trying to create a template in LMS under Configuration>Compliance Templates>Templates that will check on the trunks of the switches for a particular VLAN that is used in "switch port trunk allowed vlan", and if it is there, it should also be ad...
Tryed to make the template in "Basic" mode, but the error message was the same. The template (made in "Advanced" mode) are enclosed. Hope you can make some sense of it.GunnarR
I do not understand what I am doing wrong. If i try "Compliance Check" the job fails with the reason "Device compliance comparison failed:CM0152 Prerequisite Commands does not exist in device archive." If I try "Direct Deploy" and I choose "Enter Dat...
What I am trying is to check the command "switch port trunk allowed vlan 1,2,4,5" or "switch port trunk allowed vlan 2,4,5" on uplinks if vlan 2 is there. If it is I will run the command "switcport trunk allowed vlan add 3".In most cases, vlan 2 is n...
