Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,An interesting issue, could be silly but I don't get it.. pretty simple configuration ..Building configuration...Current configuration : 1020 bytesip vrf CIT rd 65500:100!!interface Tunnel731 bandwidth 500000 ip vrf forwarding CIT ip addres...
Hello All, We have the following setup C1 and C2 are Core Routers peering with same ISP through ebgp and ospf peering with D1 and E1. There is no firewall between C's and E but there is active/passive setup between C's and D. Now, let's assume D1 is ...
Hello Experts,I am looking for somehelp in configuring PBR in Nexus. The current setup in IOS is :interface Vlan10ip address 172.27.206.1 255.255.255.0ip address 172.27.208.1 255.255.254.0 secondaryip policy route-map Vlan_10_to_Corproute-map Vlan_10...
Hello All,The configuration for the natting is something like thisobject network Obj-10.232.50.99nat (INSIDE,ATT-Tele-Net) static 32.x.x.69object network Obj-10.232.50.98nat (INSIDE,ATT-Tele-Net) static 32.x.x.66when I do a show xlatemdcxf01b/EXTRANE...
We are in the process of migrating from VSS to Nexus hence we need to migrate from ACE module to Applicance. Any gotchas ? I would appreciate if somebody could direct me to the appropriate cisco url.Thanks,Josh
Thansk Patrick, I am seeing the same behaviour even with out the access-list. I am waiting to see how the remote router is configured . I don't see phase2 coming up when the local peer ( 98.76.54.32 ) initiated the session.
Thanks Sandeep. Although the south bound devices are dual homed but for some reasons they are acitve/standby. We will test this out with Active/Active scenario.Regards,Josh.
Hi,We have a VSS domain, with 2 BGP upstream connections (to the same AS), one on each domain-switch...
In BGP we set maximum-paths 2 I'd like to know if there is a way to load-balance over both links outgoing traffic.
I do see both bgp routes in the...
Jon,Thanks and you are right on distribution blocks to core, however I am confusing with the priority and cost on point-to-point interface .... is that a reason to configure in this way or ..from Dist 1A ------------------> Core 1A P...
