Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Posture assessment fails because Cisco Anyconnect is not recognizing the installed AV, but it only see the Windows Defender installed. The problem is, since the user has McAfee, it automatically disabled the Windows Defender and therefore no up...
Hi,
We've generated CSR on our 5520 (8.3.112) for wildcard certificate. We had a power interruption and after the reboot GUI is no longer accessible. According to the document that's how it is supposed to be.
http://www.cisco.com/c/en/us/support/doc...
Hi All,
Three AP2802 LED is cycling on Red-Off-Green-Off-Blue-Off. All APs can be seen already on 5520 WLC. According to the starting guide "Access point location command invoked". Two out of three are already added in AP group but all of them have...
Hi All,
We have a customer with two existing 2504 WLC each with 25 AP licenses. Now they are adding more APs and only bought additional AP license for the Primary only. I suggested to change their setup to N+1 so they no longer need to buy another l...
Hi Rahul,
Thanks for your response. I see your point here. So is there a way to make Anyconnect ignore Bit Defender (which is native in Windows 8/10) when there is another AV installed?
Regards,
We're using Anyconnect 4.3 for both Windows and Mac. Please note that the same case happens to user with AVAST.
Another case was the user has Norton antivirus installed. The Posture assessment was able to detect the Norton antivirus and Defender. H...
