About joagusti.v1

joagusti.v1 · 10-18-2017

Hi, Posture assessment fails because Cisco Anyconnect is not recognizing the installed AV, but it only see the Windows Defender installed. The problem is, since the user has McAfee, it automatically disabled the Windows Defender and therefore no up...

joagusti.v1 · 05-15-2017

Hi, We've generated CSR on our 5520 (8.3.112) for wildcard certificate. We had a power interruption and after the reboot GUI is no longer accessible. According to the document that's how it is supposed to be. http://www.cisco.com/c/en/us/support/doc...

joagusti.v1 · 03-29-2017

Hi All, Three AP2802 LED is cycling on Red-Off-Green-Off-Blue-Off. All APs can be seen already on 5520 WLC. According to the starting guide "Access point location command invoked". Two out of three are already added in AP group but all of them have...

joagusti.v1 · 02-02-2017

Hi All, We have a customer with two existing 2504 WLC each with 25 AP licenses. Now they are adding more APs and only bought additional AP license for the Primary only. I suggested to change their setup to N+1 so they no longer need to buy another l...

joagusti.v1 · 07-11-2018

hi David,We are also experiencing issues in WLC and Stealthwatch Flowcollector interoperability. Did you manage to figure this out?

joagusti.v1 · 10-19-2017

Hi Rahul, Thanks for your response. I see your point here. So is there a way to make Anyconnect ignore Bit Defender (which is native in Windows 8/10) when there is another AV installed? Regards,

joagusti.v1 · 10-18-2017

We're using Anyconnect 4.3 for both Windows and Mac. Please note that the same case happens to user with AVAST. Another case was the user has Norton antivirus installed. The Posture assessment was able to detect the Norton antivirus and Defender. H...

Hi, · 05-28-2017

Hi, Please make sure shared key between WLC and RADIUS server is the same. BR, John

joagusti.v1 · 05-16-2017

Thanks a lot Chris! Cheers!

Member Since	‎10-06-2015 11:11 PM
Date Last Visited	‎04-16-2019 05:03 AM
Posts	17
Total Helpful Votes Received	5

User Statistics

User Activity

ISE 2.1 Anyconnect Posture Assessment failure for AV

WLC GUI not accessible after CSR generation and reboot.

2802I Access point location command invoked

N+1 on Permanent AP Count 2504 WLC

Re: WLC Netflow to StealthWatch on 5508 running 8.2.141.0.

Re: ISE 2.1 Anyconnect Posture Assessment failure for AV

Re: ISE 2.1 Anyconnect Posture Assessment failure for AV

Hi,

Thanks a lot Chris! Cheers!