Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to block facebook website using fqdn, the problem I am facing is that it block all sites
Here is my configuration.
Step 1
#dns domain-lookup outside
#DNS server-group DefaultDNS
#name-server 8.8.4.4
Step 2
#object network OBJ-FACEBOOK.CO...
I have a Cisco WSA s160 that I want to connect with the Cisco ASA 5510. Currently my ISP cable modem is connected to the asa 5510 and it obtain its IP address via dhcp(outside interface), the inside interface is connected to Cisco switch, the inside ...
I am new to Cisco, I have asa 5510 router that I am trying to setup. I have no static IP from my ISP, I have a cable modem and Cisco 2950 switch with 5 computers.
What I am planning to do is to connect the cable modem to the Ethernet 0/0 to receive a...
I want to setup a gateway load balancing protocol, I have a question about the physical connection. My lab is setup as follows. 1 TWC cable modem, 1 Cisco 1841 router and 1 Cisco 2950 switch.
The FastEthernet 0/0 is connected to the cable modem, and...
I am studying for my CCNA and have setup my home lab. Home lab consist of TWC cable modem, Cisco 1841 Router, Cisco 2950 24 Port switch, and 1 TP link wireless router.
Cable modem is connected to the 1841 router interface FastEthernet0/0 and FastEthe...
Thank you Marvin,
Output for show run access-group
Below:
access-group ACL-inside in interface Inside
osa-ASA5510fw(config)# show run access-liosa-ASA5510fw(config)# show run access-listaccess-list Inside_mpc extended permit ip user LOCAL\godey 192....
Thank you Marvin for your response:
Below is the result of the show run access-list command.
Before
osa-ASA5510fw# show run access-listaccess-list Inside_mpc extended permit ip user LOCAL\godey 192.168.0.0 255.255.255.0 anyaccess-list Outside_acce...
Thank you Handy for your response, how do I connect the physical interface ? right now I have the ASA interface Eth0 connect to ISP cable modem, Eth1 connect to the switch. I am sure I will be using P1 interface of the WSA, my question is should the ...
My software version is:
Cisco Adaptive Security Appliance Software Version 8.4(5)6Device Manager Version 7.1(2)
Compiled on Thu 07-Feb-13 20:04 by buildersSystem image file is "disk0:/asa845-6-k8.bin"Config file at boot was "startup-config"
ASA5510f...
