Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!
With reference to the attached diagram, let's say I have 2 separate organizations (let's call them Section A and Section B) residing in separate buildings within the same campus. The core switches (6807 with Sup2T) are in a VSS configuration.
My ...
Hi!
I was recently tasked with designing a new campus network that would integrate with an existing network.
The core switch (Catalyst 6807) for the new campus network is to be connected to the core switch of the existing campus (pls see attached di...
Hi!
We recently had a customer who is thinking of deploying Meraki APs in a shopping mall that already has Aruba APs deployed; the main reason for deploying Meraki APs is to collect customer data for analytics and marketing purposes.
Are there any r...
Hi!
I've been reading the documents on OTV, and it seems that the usual configurations either involve a direct connection between the N7K core VDCs in the 2 Data Centers (where the SVIs of the VLANs to be extended are located), or at most a router i...
Hi,
I would like to ask what are my options for implementing L2 over L3 tunneling to the Internet router only for guest wireless users, who will be gaining access via a captive portal? Based on the requirements from the customer, I believe the aim is...
What if I want the existing security VLAN SVI to continue residing on the existing core switch, and for this security VLAN to be trunked over to the new core switches?
And for the SVIs for the new VLANs on the new core switch to reside on the new cor...
Hi Philip,
Thanks a lot for your reply.
Am hoping for someone who has implemented this in the manner that I had described above, to highlight any potential problems even though it works in theory
Thanks for your prompt reply, Richard.
There's actually no issue with configuring a physical IP for the tunnel source and loopback for the tunnel destination; I realized a stupid configuration mistake on my part (wrong configuration).
Thanks. I wanted to be sure that it was not a configuration mistake; I had thought that since the 2248 is supported, the 2224 should also be supported. I'm guessing that if I had followed the above steps exactly and still couldn't get it to work, the...
Any updates to the list of switches supported?N2K-C2248PQ-10GEN2K-C2248TP-E-1GEN2K-C2248TP-1GEN2K-C2232PP-10GEN2K-C2232TM-E-10GE I tried to set up the FEX (N2K-C2224TP) connected to the leaf switch, but was not successful in getting it up.The error w...
