Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I'm simply configuring a WAN failover solution between 2 routers.I have 2 7206VXR routers. Each WAN connection comes from the same ISP. I have HSRP running successfully inside, but need some clarification on the WAN side in terms of BGP ...
Hi all, I have a scenario that requires broadcasts to be blocked at my main headswitch (WS-C6506_s720 - IOS 12.2(18)SXD7b) which is running as simply a L2 headswitch right now, and not routing. I have two ports going upstream to two 7206VXR routers, ...
hey all, I need to give traffic bound to specific URLs priority on the network... www.cisco.com for example. What would be the best way to configure this? I'm running on 7206VXRs. Thanks.
Hi all,WCS ver 5.2.110.0When I create a LWAP template, to apply a WLAN override to all my APs, the WLAN I'm looking for is not in the list. Previous WLANs are listed, that are no longer resident on the WLC4404. The current WLAN configured in the WLC ...
Hey all, Basically, I have 2 ds3s. rtr1 on ds31, and rtr2 on ds32. I have BGP on both, same ISP, same AN with my ARIN block. I have half my block advertised on rtr1, the other half on rtr2. I have rtr3 hanging off rtr2, which handles a large PAT netw...
We moved to stateful DHCPv6 with no luck, but based on some packet inspection found that RAs were not being passed through to clients (no default gateway received). Enabling RA throttle policy on the WLCs fixed our issue, though we have not tested th...
My confusion lies with the secondary vlan120 you mentioned. How does that relate to vlan100? Thanks for the response!Also I read somewhere that VTP needed to be set to transparent to accomplish what I need... is this accurate?
