Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Sirs!
Could someone help me to resolve the issue with the ISE. Both: WLC and ISE reachable and can communicate. I can integrate them manually. I did it (but for wired LAN 802.1X)!
Now I have to implement the Guest access (self-registration), an...
Hello Community! I have the folloving task: get the internal web server (IPv4 address - 192.168.1.10) to be reachable from IPv6 Internet.I used NAT64 technology. The part of the config is:
R1!interface GigabitEthernet0/2.558encapsulation dot1Q 558sta...
Hello Community! I have the folloving task: get the internal web server (IPv4 address - 192.168.1.10) to be reachable from IPv6 Internet.I used NAT64 technology. The part of the config is:
R1!interface GigabitEthernet0/2.558encapsulation dot1Q 558sta...
Dear Professionals!I ask You to suggest what it is necessary to use in the VXML script ( it is in attachment) that it would have finished the call control?My problem is that - once the script is transfered the call to the Secretary, she can't transfe...
Hello Harold!
Thanks for your help, time and enthusiasm!
Now you are absolutely right -) in this case nat64 works.
It bit strange for me that I should use different subnets in both sides: v4 and v6. I would recommend Cisco to add these nuances as t...
Hi Harold,
Tried with more specific ACL but result is the same.
I found interesting fact. As long as I use different v6 subnet as Stateful Prefix (for example 2A02:E5C0:1::/96) and new v4v6 static - R1 starts to create NAT64 transtalion. But (and i ...
Hello Harold!
Thanks for your reply. Actually I have the ACL:
R1#sh run | sec NAT_v6nat64 v6v4 list NAT_v6 pool POOL_v4 overloadipv6 access-list NAT_v6 permit ipv6 any any
PS I am sorry that I created two similar cases: this one and "IPv6 NAT64 v4v...
