Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a weird situation where my 9200L box do not detect the file from USB. the logging shows that the usbdrive was removed but never shows it was inserted, Has anyone tries specifically Cisco 9200 Catalyst boxes upgrade using USB ? Also, what shoul...
The reachability of each interface can be done from either leg, still my asa failover is in failed state. Below is the show failover result from secondary leg (acting as active box)Failover OnFailover unit SecondaryFailover LAN Interface: failoverlan...
So there were 2 Cisco ASA 5000 series boxes and their failover lan and state interfaces were connected via 2 C9300 switches. FW1>>FailoverLAN>>>>>SW1>>>>>Po1<<<<<<<<<<SW2<<<<<<FailoverLAN<<FW2FW1>>FailoverState>>>>>SW1>>>>>Po1<<<<<<<<<<SW2<<<<<<Fail...
My query is rather simple. I have a Single C9300 switch deployed in the infra. (standalone switch)I now have another C9300 switch (same model and port as the existing one), which I need to add in the system. Can I add the new switch to the existing ...
Basically usb-summary shows usb of 8GB, but not logs of detected usb. Rather, usb removed logs are seen Switch#show usb-devices summaryUSB Device: EHCI Host ControllerBus: 01 Port: 00 Cnt: 00 Speed: 480Vendor: 1d6b ProdID: 0002 Rev: 4.19Serial Numbe...
Yes. Interfaces are part of the right contexts. I did not touched/configured the ASA in anyway. The failed state showed up after I upgraded the switches in between the two ASAs. I am guessing after the reboot of both the switches.
