Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a use case to connect P1 and P2 to different networks (same building but segmented networks0, but I need the routing table for each interface to be separate so traffic coming into P1 will use the DF route for P1 network, and traffic coming ...
Using the same edge internet connection but the interfaces will connect to two different "core" routers behind the edge. So I assume if I put 0/0 route for P1 and 0/0 route for P2, only the P1 route will be used or will they load balance?Either way d...
I was able to make it work using different device groups and shell profiles instead of trying to combine mulitiple together. Is your issue with IOS devices or NXOS devices (role-based auth)Justin
Making different device groups and shell profiles mapped to different authorization profiles fixed my problem BTW.Here is the setup I did for Juniper. I will try the netscreen one (last picture) later today/tomorrow
