Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to create a separate VLAN for our WAPs to segment them from the management VLAN I setup. With this I plan to subnet the network I created, a /21, to a /23. When I try to save the new WAP VLAN I get the error below:I've even switch the mana...
I've been working on configuring a C9407R w/ two SUP2 modules installed and flashed both with IOS-XE 17.10.1 (the only image options available to flash on these modules are 17.7.1, 17.8.1, 17.9.1, 17.10.1 - all ED). This platform will be replacing a ...
All I did specifically was launch the driver setup utility (i.e. 'Cisco_usbconsole_driver_3_1') and go thru the uninstall process with that. Once that was complete, I can't remember if I had to restart my system, but the COM ports would display under...
In my case I had the Cisco USB console driver 3.1 installed prior to upgrading to Win11, where it worked on Win10 until then. I followed all these steps and then some, and still wasn't able to get it work.I happened to uninstall the driver, reboot, a...
So that's what I had to do: set the management as 172.16.224.0 /23, and WAP as 172.16.226.0 /23. My understanding was that the MX's IP for the whole inside network (172.16.224.0) and as the gateway for everything should be 172.16.224.1, but it appear...
What's the significant difference between a "standard type 9" hash and a "convoluted type 9" hash?What's the specific method of defining a convoluted type 9, and or switching between the two? UpdateFound my own answer from NSA's Network Infrastructur...
