Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is the scenario that caused one of my remote offices to lose connectivity to the home office:
Home Office router:
Gi0/0 192.168.1.1
Gi0/1 10.13.251.200
Remote Office Router:
Gi0/0 192.168.1.2
Gi0/1 192.168.48.2
Engineer told HOR the following...
I have a 5010 that simply won't load any system image. Loads the kickstart image just fine, but once at the Switch(boot)# prompt just give me garbage when I enter "load bootflash:n5000-uk9.5.1.3.N2.1b.binRestarting system.Loader Version pr-1.3loader...
Does anyone have any experience moving from a 3rd party support service BACK to SmartNet with Cisco? I am concerned that after having my devices with a 3rd pary support provider that Cisco will view my devices as having lapsed coverage and will be d...
Hello,I have a metro ethernet connection with 3 switches (Switches A, C, and E) at 3 different locations each with a single interface into the metro-e cloud and each interface configured as an 802.1q trunk. Switch A is in VTP domain xxx-xxx and Swit...
How can I determine which router to purchase based on port density and throughput ? I need to terminate two 45mbps ethernet connections into the router. A primary and 2ndary connection. The ethernet connections connect our office with two data cen...
Thanks for the response. No VPN. The config is really that basic. Brand new connection. I have Network on Demand layer 2 service from AT&T. HO Router has interface on 192.168.1.x /24 subnet. HO is .1, remote office is .2. No NATing, all static...
I have nothing. I am designing it. Cox is going to hand us an RJ45 connection that will plug into their network. Its a dedicated 45mbps connection over ethernet. Our data center and our office will be connected over this connection just as throug...
Thanks for the resposne. I just mentioned the PAT to get the point across that I was not statically NATing the internal users to their own IPs. The PAT is in place for all outbound traffic. I have read that you can only use the fixup for ESP if th...
Not sure this is the same thing, but the IDS functionality of the PIX IOS drops packet above a certain size due to security concerns. I could not pass packets about 993bytes or something like that on PIX 506E's running 6.3.4 until I disable a couple...
