Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a Cisco C1117-4P connected to a vdsl line. However, it has recently stopped being able to connect to the carrier. It worked for over one year and then just stopped. I have tested the line with other routers, and it works fine, so I know ev...
Hi,My customer has created vlan100, which is dedicated to network management, and we have allowed them to monitor some of the interfaces on the ASR920s. Therefore I created a new instance, encapsulated dot1q 100 and created a bdi. However, after 5 mi...
Hi All,I have a Cisco ISR c1117 router at home that I use to replace the standard sky router. I had setup everything and it was working perfectly fine, I also upgraded the iOS-xe and had full connectivity until I came back from holiday.I've plugged i...
Hi M02@rt37 The VDSL controller has been set to auto. It has always been set like that. The interface configuration has stayed the same, and I have compared it to other customers. It looks fine. On the front of the router, the vdsl interface repeated...
@Leo Laohoo @andrew.butterworth Hi, Apologies for bumping this thread. I realised I had the same issue with the bootrom version. Since upgrading the firmware the router lost power and obviously rebooted but for whatever reason the ethernet is hard do...
@Georg Pauwen Hi Georg, Sincere thanks for your reply. I have tried that previously and tested again but it still says the same. I've attached the boot up logs and sh controller..
@paul driver Hi, have you managed to view the output from my last post? I dont understand why the modem status says the "line is not initialized"? I've changed all phone cable plus dsl filter, fiddled with different firmware versions and updated the ...
Hi Paul,Many thanks for your reply, it's much appreciated. After plugging in the new sky router everything works, I haven't tried the old one. As mentioned, I have changed my cisco router to correspond with the new sky routers config but to no avail....
